How to remove a garbage disposal mounting bracket

How to remove a garbage disposal mounting bracket how to#
How to remove a garbage disposal mounting bracket install#
How to remove a garbage disposal mounting bracket code#

Hook the connection back up to the new garbage disposal. Remove this plug or you can damage your dishwasher or have a huge mess to clean up.

You need to wrap the ground wire back around the green screw so that it is grounded correctly.Дishwasher Hookup:В Look closely at the disposer connection to the dishwasher! Likely, there is a plastic or metal plug that you will need to remove.

How to remove a garbage disposal mounting bracket code#

Plug in the cord from your home to the new unit by matching the color-coded wires to the color code on the adapter. Hooking Up Power:В Unscrew the metal faceplate from the bottom of your new disposal. Depending on the model you have, this mounting ring will either slide on or need to be screwed on. Now you can attach the new mounting ring to the mounting bracket. Mounting Bracket:В Slide the rubber gasket from your new disposal onto the new mounting bracket and then screw the new bracket into the sink. Our Affordable Service Technicians recommend that you place something heavy on the top of the phalange to help set it securely as it dries. Putty The Flange:В Apply your plumbers putty to the underside of your metal flange and reinsert it into the hole in your sink.

How to remove a garbage disposal mounting bracket install#

Sink Flange:В Remove the sink flange by using a hammer to gently tap it from beneath and pull it up from above.Д¬lean-Up:В You are almost ready to install the new one! Take the time to clean any of the old putty and buildup before we begin the installation process next. Reuse Some Of The Parts:В Remove the rubber snap ring from inside the old mounting bracket, as well as the old mounting bracket. Take pictures with your cell phone if you donвЂ™t think youвЂ™ll remember the orientation of the wires. Black or red is вЂњhotвЂќ white is the вЂњcommonвЂќ wire green or bare wire is the вЂњgroundвЂќ. You can now safely set your old disposal off to the side. Slip the copper ground wire out from underneath the green screw that is holding it in place, and then you can unclip the two additional wires. ItвЂ™s time to disconnect the power from the old unit- you may need your screwdriver and needle nose plier for this. You canвЂ™t be too careful with electricity. Wire Disconnection:В If youвЂ™re not comfortable with this step, contact Affordable Service right away.

Once this is loosened, the garbage disposal will come free- be prepared because these can weigh upwards of 15 pounds.ДЇaceplate:В Unscrew the metal faceplate from the bottom of the disposal. You should be able to loosen this with a small screwdriver. Locate Mounting Ring:В This is located at the top of the garbage disposal: grasp the grips and turn it counter-clockwise.

Some older model kitchens also have the dishwasher tube attached to the disposal, this needs to be taken off as well.

How to remove a garbage disposal mounting bracket how to#

Make note of the orientation of the pipesвЂ“ take pictures if you need to remember how to reassemble. Note that you may need to disconnect the entire вЂњPвЂќ trap for this step. Pull The Tubes:В Pull the waste tube to disconnect it. Check it once youвЂ™ve turned the power off by testing it with your live wire tool. Turn Off The Power:В Make sure youвЂ™ve turned the power off from the breaker. All you have to do now is make space under your sink, gather your toolsвЂ“ so, letвЂ™s get started! OK- your garbage disposal has gone out, youвЂ™ve gone to your local hardware store and talked to a sales associate and have the correct model in hand.